Removing Drip Edge From Rolled Roof

Drip edge or drip cap is either plastic or sheet metal.

Removing drip edge from rolled roof. Metal d flashing or drip edge is sometimes installed only along the eaves edge but it is actually required by the 2012 international residential code irc at eaves and gables of shingle. Use a starter strip or cut pieces for a starter course. Attach with nails along the top edge of the strip. The best way is to install the roof drip edge only along the eaves first then place ice and water barrier in the snowbelt or felt paper underlayment over the drip edge.

Use a flat pry bar and hammer to remove the nails holding the eave strip to the roof decking. At the eave i d guess that if you install the flashing under the roll roofing you d risk getting moisture between the flashing and the roll roofing. Install peel and stick roofing in a similar manner. Slide the flat bar under starter course and pry out the nails.

Begin at the lower corner of the roof and gradually progress to the top. But do not push it through the fascia. This lets any water that gets on the roof run down the underlayment and over the drip edge. Install roll roofing when the temperature is at least 50 degrees fahrenheit to keep the material from cracking.

On some roofs you may need to remove a couple of shingle nails to make some room to work. Use a flat pry bar to remove drip edge nails along the eave and rakes. Rip cut the starter strip or starter pieces so that they butt up against the second course of existing shingles and are even with the front edge of the existing roofing. Tack the end into position with the roofing nails and press the nail within the drip edge and into the roof covering.

Find and fix a leaking roof. It not only protects the roof but it also protects the fascia. Removing drip edge eave strips. 12 roof repair tips.

Slip the eave strip out from under the shingles. Raise the shingles and push the top rim of your drip edge beneath them.