Removing Row Of Siding

If the siding is hard to remove try tapping it with the palm of your hand.

Removing row of siding. How to remove and replace a section of vinyl siding. Cut the nails at the bottom of the row above the boards you re replacing. If it remains stuck double check to see if. To get at the nails carefully wedge out the bottom of the siding 1 8 to 3 16 in.

Removing a damaged section of wood siding is relatively easy. The wedges which are 1 to 2 inches in. To remove the uppermost piece start at one end of the bottom of the first panel and push the end of the zip tool up under siding until it hooks onto the underside of the lip. Repeat until you re at the ground and then remove the surrounding trim.

Use a small hacksaw with a sharp blade. Use a cat s paw or other small pry bar to pull the nails from the course you need to remove. Step 1 slide the thin edge of a flat pry bar carefully under the lower edge of the first piece of hardieplank siding to be removed. You won t be able to.

You should be able to slide it horizontally and remove it from the channel to expose the nails from the second row down. Isolate the piece of siding you need to remove and find its outermost edge on either side. Start by lifting an overlapped piece of vinyl on the top row. Look for a horizontal seam between two courses of vinyl siding.

Use a mallet or hammer to gently drive the tip of the bar up behind the siding if necessary. Slide the separating tool underneath the bottom edge of the siding piece that is directly above the piece. If the piece still seems attached to the wall gently pull it outward so it comes free of the channel holding it in. If you have a hammer a cat s paw tool and a few wood wedges you can slide the siding out.