Repair Sticking Shower Door

3 open the shower door and stand a 2x4 block underneath its outer bottom corner.

Repair sticking shower door. The hinge can slide down over time so loosening adjusting and tightening can solve the problem. This always works but it s a major hassle. Straight to the point. Look for screws or caps that can be popped off to reveal screws.

Specifically you need to check the hinges handles and latches. Shower door hardware is almost always put together using screws. When the planing is done you have to refinish the planed edge. This is a simple repair to a common problem.

Turn the screws counterclockwise so that they are loose but do not remove them. Repair a garage door opener. 2 loosen the screws holding the handle to the shower door. If the sliding doors on your shower or bathtub don t glide smoothly repair them soon.

Fix a sticky shower door. For the above shower door repairs the fix usually has to do with tightening up things. Fixing your door should take about one to two hours. Shim the door edge using a two by four and wood shims.

Tighten the screws that go into the door and the screws that go into the door frame. Like the sticking door the answer to a sagging door is to tighten the screws. A door that drags on the lower track will eventually do permanent damage to both the door and the track. Find the screws that connect the glass door to the frame at the hinges.

The standard prescription for fixing a sticking door is planing the rubbing edge so it swings freely. Protect the shower or tub from scratches with a drop cloth. Adjust the frame of the door by loosening all of the frame screws including the handle screws. You have to remove the door and lug it out to the garage.

1 use screwdriver to loosen the screws in each corner of the shower doorframe. Do not over tighten the screws or you may strip break them. If it s a matter of the door edge hitting the door frame use your philips screwdriver and tighten the screws on either the top middle or bottom hinge. 4 slide shims into the space between the 2x4 block and door.

Unscrew the guide at the lower edge of the sliding door. Then tap the outer edge of the door from.